But good thing You have a menu of choices when plugging it in to PC with USB (Camera, mass storage, and something else I forget right now. I'm affraid I'll break it if I try to take the card out again.
Snaps and Video can also be done without PC.
You can also connect it to a PC with a regular microsd cable to view live on a big monitor. Along with a bunch of the tools recommended by sthetix Trying to remove the mask would likely pull the pad. get it close to prevent wiggling, but don't cover it, because now I would never try to fix that with a proper wire myself. For future reference, you never want to mask right on top of a point like that. You really shouldn't use bigger than 0.1mm on clk and cmd. The wire looks way too big for such a small point, and I can't even tell if there's enough solder there. After seeing the difference, I felt stupid for ever trying with the smaller scope (it didn't leave much room to work the iron, either) The one I have now was only like $79, and has a 7" screen, and can snap/video. I had a cheap sub-$50 scope on my first attempt, and I screwed it up. What are you using? And you tried this without a microscope? That was not smart.
Micro sd card switch mod#
You took the wires off of the mod chip, so use the open end of the wires to check your readings in diode mode. Is there a way to make my Switch work again? I'm not sure if simply desoldering the wires from the chip is enough to properly unmod the Switch but I couldn't find any proper instructions online. Tried to boot it holding the VOL+ and VOL- buttons but still getting the blue screen. I desoldered and isolated all the wires from the chip and tried to boot the console. Since I couldn't make the modchip work I decided to disconnect it. I don't think it's either one of those since I've been using tested good cards and opened the Switch and carefully inspected the SD connector and found no issues, all the pins look fine, nothing is bent or damaged. I've opened an issue in the hekate github repo and got a response that it's either fake or corrupted SD card or the SD connector itself (Update: contacted CTCaer directly and we came to conclusion that the issue is with one of the RAM modules). I've tried several other known good cards with no success. I've tried the old card but that didn't help.
Micro sd card switch install#
The next day I went to install a larger SD card and got an error message. It was working and booting fine as soon as I installed the modchip but it was late so I shut it down and put it on charger for the night. I'm having issues with my freshly modded Switch OLED.